Filter
Top Products
MR-3018/3020/3021/3022 © 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 14
[J] Pre-reading roller
[K] Post-reading roller
(1) Take off the pre-reading upper guide.
( P. 4-13 "[H] Pre-reading guide")
(2) Take off the read motor drive section.
( P. 4-19 "[C] Read motor drive section")
(3) Remove 1 bushing, 1 screw, 1 pulley and 1
bearing from the rear side of the pre-reading
roller shaft.
Fig. 4-38
(4) Remove 1 clip and 1 bushing from the front
side of the pre-reading roller shaft.
(5) Take off the pre-reading roller.
Fig. 4-39
(1) Take off the pre-reading lower guide.
( P. 4-13 "[H] Pre-reading guide")
(2) Disconnect 1 connector.
Fig. 4-40
Screw
Pulley
Bearing
Bushing
Pre-reading roller
Bushing Clip
Connector
07/06