Filter
Top Products
© 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved MR-3018/3020/3021/3022
DISASSEMBLY AND ASSEMBLY
4 - 19
4
[C] Read motor drive section
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Take off the fan motor.
( P. 4-18 "[A] Fan motor (M4)")
(3) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø10.2 mm, active coils – 12.5)
Fig. 4-51
(4) Remove 3 screws, and then take off the read
motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3),
and then attach the spring removed at step
(2). Then fully tighten these screws.
Fig. 4-52
(5) Remove 1 spring. (Spring: Outside diameter
of coil –ø8.8 mm, active coils – 12.5)
(6) Release the harness from 2 harness clamps.
Fig. 4-53
Connector
Spring
Read motor
Spring
Harness clamp
Harness clamp
05/12