Toshiba MR-3022 Scanner User Manual


 
© 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved MR-3018/3020/3021/3022
ADJUSTMENT
5 - 15
5
5.5 Adjustment of Horizontal Position
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
(See the Service Manual or Service Handbook of the applicable equipment.)
Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with a center line in the following procedure.
(1) Place the chart provided as an original with its face up on the original tray of the RADF.
(2) Press the [START] button.
(3) Fold the copy in half and check if the center line is misaligned.
[B] Adjustment
(1) Turn the power ON while pressing [0] and [5] simultaneously.
(2) Key in [358]*1 / [3043] *2 and then press the [START] button.
*1 : For e-STUDIO352/353/452/453
e-STUDIO281c/351c/451c,
e-STUDIO2500c/3500c/3510c,
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C,
e-STUDIO202L/203L/232/233/282/283,
e-STUDIO205L/255/305/355/455
*2 : For e-STUDIO2040C/2540C/3040C/3540C/4540C,
e-STUDIO206L/256/306/356/456
If the center line of the copy image is shifted to the front side of the equipment, enter a value
larger than the current one.
Note: Note:
Changing one value shifts the copy image by 0.0423 mm.
Fig. 5-28
If the center line of the copy image is shifted to the rear side of the equipment, enter a value
smaller than the current one.
G
11/12