Filter
Top Products
4.5 WLAN Card 4 Replacement Procedures
NB250/NB255 Maintenance Manual 4-21
4.7 Power Board
Removing the Power Board
Remove the power board according to the following procedures and Figure 4.12.
1. Use tweezers to release the latches on the left and right sides of the connector by pushing
in the direction of the arrows in Figure 4.12.
2. Remove the power board cable from the motherboard.
3. Press down the latch that protrudes to the power board on its right side. Push the power
board in the direction indicated in figure 4.12 and slide the power board out.
4. Remove the power board from the logic upper assembly.
Figure 4.12 Removing the Power Board
Note: Be careful not to damage the Power Board when connecting it with the cable. Make
sure the card is seated in the correct position.