Filter
Top Products
36
1
Unplug power cord.
2
Wait until lamp is suffi ciently cooled.
Wait for at least 1 hour.
3
Remove the lamp cover.
Loosen the two screws, raise the lamp cover with
your fi ngers to remove the lamp cover. Use care
to avoid any damage to nails and/or tip of your
fi nger(s). If you have any diffi culty in removal, you
can use a screwdriver or any other smaller tool for
your convenience.
4
Pull up the lamp.
Loosen the two screws holding the lamp in place,
and pull up the handle to remove the lamp.
A lamp is consumable supply. If used for extended periods, images will appear dark, and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The life-
time of the lamp depends on condition of use.) If this happens, replace it with a new one.
CAUTION
If you have been using the projector, the lamp will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
If the lamp should break, please handle with care to avoid injury due to broken pieces and contact your
dealer for repair service.
WARNING
If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealership when the
lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger of damage from falling
pieces of glass if the lamp is broken. Besides, working at high elevations can also be hazardous. Do not attempt to
replace the lamp by yourself.
When replacing, always use lamp “PA3976U-1ET2” (sold separately). If the lamp other than the specifi ed one is
used, it may cause a malfunction or damage to the unit due to the difference in the connector shape or the lamp rate.
1
2
3
Lamp cover
1
2
4
Lamp replacement