Filter
Top Products
4 Replacement Procedures 4.5 Memory module
4-20 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Installing the Memory module
To install the memory module, confirm that the computer is shut down. Then follow the steps
below and refer to Figure 4-7 and 4-8.
CAUTION: When installing the memory module, make sure the computer is powered off.
Inserting a memory module with the power on might damage the module or the
computer itself.
Never press hard or bend a memory module.
1. Insert the memory module(s) into the connector(s) slantwise and press it to connect
firmly.
CAUTION: After installing the memory module, make sure that the memory module is
secured with the left and right latches.
2. Install the memory cover and secure it with the screw.
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, check that it is connected correctly.