Filter
Top Products
4 Replacement Procedures 4.23 VGA Board
3. Remove the heat sink from the VGA board by removing the four screws. Follow the
order indicated by the numbers on the heat sink in reverse to remove the screws.
Figure 4-69 Removing the VGA heat sink
Installing the VGA Board
To install the VGA board, follow the steps below and refer to the figure in the preceding
section:
CAUTION: If you remove the heat sink, please use soft cloth with alcohol to clean the
VGA board and heat sink. Reapply 7762 grease before installing the heat sink.
1. Connect the heat sink to the VGA board by securing it with four screws. Follow the
order indicated by the numbers on the heat sink to tighten the screws.
2. Seat the VGA board and secure it by placing the three M2.5x4 screws and tightening
them.
4-58
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual