Filter
Top Products
Chapter 4 Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly.
1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly
with hands on the base assembly.
2. Secure the hinges with the following screws.
‧M2.0 4F FLAT BIND screw x4
Figure 4-8-10 Secure the hinge screws
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the system board.
Satellite T110D / Satellite Pro T110D / PORTEGE T110D Maintenance Manual (960-Q08)
28