Filter
Top Products
HW Setup
Portégé M200 75
Portégé M200 Version
1
Last Saved on 03/11/2003 12:04
ENGLISH using Euro_M.dot –– Printed on 03/11/2003 as IM_M20EN
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Built-in HDD ->
2nd HDD -> PC
Card (Default)
The computer will look for the Builtin HDD first,
next the 2nd HDD and then the PC Card.
(Default)
2nd HDD -> Built-
in HDD -> PC Card
The computer will look for the 2nd HDD first,
next the Builtin HDD and then the PC Card.
Built-in HDD ->
PC Card -> 2nd
HDD
The computer will look for the Builtin HDD first,
next PC Card and then the 2nd HDD.
2nd HDD -> PC
Card -> Built-in
HDD
The computer will look for the 2nd HDD first,
next the PC Card and then the Builtin HDD.
PC Card -> Built-
in HDD -> 2nd HDD
The computer will look for the PC Card first, next
the Builtin HDD and then the 2nd HDD.
PC Card -> 2nd
HDD -> Built-in
HDD
The computer will look for the PC Card first, next
the 2nd HDD and then the Builtin HDD.
If a boot command is not found on the first detected HDD, the system will
not boot from the other HDD. It will search the next device in the boot
priority for a boot command.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE] Sets PXE as the protocol. (Default)
[RPL] Sets RPL as the protocol.
PC card HDD boot is supported only by the PC card slot on the
computer. Support is guaranteed only for TOSHIBA PC card HDDs.
When you assign a PC card HDD top priority, “PC” is not displayed.
However, the PC card HDD takes the position of HDD in the Boot Priority
Options list above.