Filter
Top Products
195
If Something Goes Wrong
Resolving a hardware conflict
Removing the AccuPoint II cap
2 After cleaning the cap, position it on the peg and press it into
place.
NOTE: The peg is square, so be careful to align the cap’s
hole with the peg.
Display problems
Here are some typical display problems and their solutions:
The display is blank.
Display Auto Off may have gone into effect. Press any key to
activate the screen.
You may have activated the instant password feature by pressing
Fn and F1 simultaneously. If you have registered a password, press
Enter, type the password and press Enter. If no password is
registered, simply press
Enter. The screen reactivates and allows
you to continue working.
If you are using the built-in screen, make sure the display priority
is not set for an external monitor. To do this, press
Fn and F5
simultaneously (once). If this does not correct the problem, press
Fn and F5 simultaneously again to return the display priority to its
previous setting.