Filter
Top Products
Chapter 4 Replacement Procedures
4.12 System board
CAUTION: 1. when handling the system board, always hold by the edges. Do not touch
the printed circuit face.
2. if replacing with a new system board, execute the subtest01 Initial
configuration in section 3.3 “Setting of the hardware configuration”.
Removing the system board
The following describes the procedure for removing the system board (See Figure 4-12-1).
1. Disconnect the LAN BOARD FFC, LCD CABLE, Antenna cable, Audio board
FFC, HDMI FFC, Bluetooth cable, SIM CARD FFC, TP board FFC, Power
Board FFC, HDD cable from the connector on the system board.
2. Remove the following screws securing the system board and remove the system
board.
M2.03.0F FLAT BIND screw x2
3. Disconnect the RGB cable and DC-IN cable from the connector on the system board.
Figure 4-12-1 Remove the system board
Satellite T110D / Satellite Pro T110D / PORTEGE T110D Maintenance Manual (960-Q08)
40