Filter
Top Products
Additional Information38
English
Lamp warning message
The following Lamp warning displays will remind you to change the lamp. The
lamp hour information is also available in the Information > Lamp time
menu.
Replacing the lamp
CAUTION: HOT SURFACE! The lamp may be very hot after use. Before
replacing the lamp, turn off the projector, unplug the power cord, and allow the
projector to cool for at least 45 minutes.
The lamp unit contains mercury. Disposal of mercury may be regulated due to
environmental considerations. Dispose of the used lamp unit by the approved
method for your area. Contact your local authorities or www.eiae.org (USA only).
A lamp is consumable supplies. If used for extended periods, images will appear
dark, and the lamp could burn out. This is characteristic of a lamp, and is not
malfunction. (The lifetime of the lamp depends on condition of use.) If this
happens, replace it with a new one.
Message Status
The lamp has been in operation for 2000
hours. Install a new lamp for optimal
performance.
WARNING
• If the projector is mounted on the ceiling, ask your Toshiba dealership to
replace the lamp. Replacing the lamp at a high site by yourself may cause
you to drop down, thus resulting in injury.
• When replacing, always use lamp “TLPLW7” (sold separately).
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause
burn injuries. Wait for the lamp to cool (for at least 45 minutes) before
replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken
pieces and contact your dealer for repair service.