Filter
Top Products
4.9 LCD Module 4 Replacement Procedures
Installing the LCD Module
NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Install the LCD module according to the following procedures and Figures 4-19, 4-20.
1. Turn the LCD right side up.
2. Place the LCD bracket in the correct position and secure it with two M2 x 2.5 black
flat head screws on each side.
3. Place the LCD module in the correct position and secure it with two M2.5 x 5 black
flat heat screws on each side.
4. Connect the LCM/CCD Cable to Connector on CCD Board.
CAUTION: When installing the LCD module, please follow below instruction:
When plug in LCD/FL cable into LCD module connector, need to plug horizontally. For
Sharp panel, if LCD/FL cable connector is not plugged horizontally, it may be damaged.
TOSHIBA NB100 Maintenance Manual 4-35