Filter
Top Products
30
Maintenance & Troubleshooting
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you
use the remote. Symptoms of low battery charge include erratic
responses when using the remote and a reduced range of opera-
tion.
Follow these steps to replace the batteries:
1
Turn the remote face down in your hand.
2
Slide the battery cover off the end of the remote.
3
Remove the old batteries and dispose of them in an environ-
mentally proper manner.
4
Install two new AAA alkaline batteries. Make sure you install
each in the correct direction.
5
Slide the battery cover back on the remote.
Using the Kensington Lock
The projector has a Kensington Security Standard connector for
use with a Kensington MicroSaver Security System (Figure 22).
See “Optional Accessories” on page 37 for ordering information.
Refer to the information that came with the Kensington System
for instructions on how to use it to secure the projector.
F
IGURE
22
Installing the Kensington lock