Filter
Top Products
24 and 16 Port Smart Switch II – User Manual Page 6
Desktop Installation
1. Locate the switch in a clean, flat and safe position that has easy
access to AC power. Ensure that there is sufficient clearance
around the switch to enable air circulation.
2. Fit the self-adhesive rubber feet to the underside of the switch.
Installing The Switch Into a 19” Rack
1. Identify the required locations and ensure that there is at least
10cm clearance at the front and rear of the switch to allow cables
to be accommodated.
2. Fit the supplied rack mount bracket on both side plates of the
switch using a screwdriver.
3. Locate the switch into the rack and align the holes in the brackets
with holes in the rack vertical strips. Secure the switch using the
supplied bolts.
Installing The Optional Fibre Uplink Module
1. Remove AC power from the switch.
2. Remove the two screws securing the front panel blanking plate.
3. Observe anti-static handling precautions and carefully fit the
plug-in module into the switch and secure it using the
thumbscrews.
Product Number 0-1591093-x 0-1591047-x Issue 1
© Tyco Electronics 2005