ViewSonic PJL6243 Projector User Manual


  Open as PDF
of 177
 
20ViewSonic PJL6243
20
TOMAINTAINTHELIFEOFTHELAMP,
ONCEYOUTURNTHEPROJECTORON,
WAITATLEASTFIVEMINUTESBEFORE
TURNINGITOFF.
Power off? disappears after 4 seconds.
TurningOfftheProjector
Press the ON/STAND-BY button on the top control
or on the remote control, and Power off? appears
on the screen.
Press the ON/STAND-BY button again to turn off
the projector. The POWER indicator lights red and
the cooling fans stop (default setting), and you can
unplug the AC power cord.
If L1 is selected in Fan menu (p.55), the POWER
indicator starts to blink red and the cooling fans keep
running for about 60 seconds, then the POWER
indicator lights red and the cooling fans stop. You
can unplug the AC power cord even if the cooling
fans are still running.
1
2
Note:
• When the Direct on function is set to On,
the projector will be turned on automatically
by connecting the AC power cord to an AC
outlet (p.49).
• The running speed of cooling fans is
changed according to the temperature inside
the projector.
• Do not put the projector in a case before the
projector is cooled enough.
• If the WARNING indicator blinks or lights red,
see “WARNING indicator” on page 58.
• While the POWER indicator is blinking, the
lamp is being cooled down and the projector
cannot be turned on. Wait until the POWER
indicator stops blinking to turn on the
projector again.
• The projector can be turned on after the
POWER indicator lights red.
• When L2 is selected in Fan menu (p.55) and
the projector is turned on right after it turns
off, it takes a while to start projecting.
Basic Operation
DONOTOPERATETHEPROJECTOR
CONTINUOUSLYWITHOUTREST.
CONTINUOUSUSEMAYRESULTIN
SHORTENINGTHELAMPLIFE.TURNOFF
THEPROJECTORANDLETSTANDFOR
ABOUTANHOURINEVERY24HOURS.
Note:
When using the Direct Off function, you can not
restart the projector immediately after the power
is disconnected. If the external power supply is
suddenly cut off, the fans stop
immediately. The
lamp remains high temperature
and needs to be
cooled.
You can disconnect the power cord from the wall outlet
or turn off the breaker even during projection without
pressing the ON/STAND-BY button.
Direct Off Function
 previous next