Filter
Top Products
The Acer Extensa 365 Series (Model 367T, 367D, 366D) comes stan-
dard with 32MB (16MB soldered + 16MB module) of memory. It can be
expanded to a maximum of 80MB* by installing the following Viking
Components memory options into its one available expansion slot.
Description Viking P/N
16MB SDRAM Memory Module AC80420, RAC80420
32MB SDRAM Memory Module AC80421, RAC80421
64MB SDRAM Memory Module AC80422, RAC80422
*Requires the removal of the standard memory module.
Caution:
Electro Static Discharge (ESD) can damage electronic components. Before
touching the memory module, ensure that you are discharged of static elec-
tricity by touching a grounded metal object.
INSTALLATION INSTRUCTIONS:
1. Turn the computer off and disconnect the AC power supply and any
other cables from the unit.
Note: If the unit appears to be powered down, ensure that it is not in
Suspend mode.
2. Turn the computer upside-down. Remove
the battery from the system. If you are not
familiar with this procedure, please refer to
your computer’s “
Owner’s Manual.”
3. Facing the front of the computer, locate
the memory expansion cover on the right-
side of the bottom panel. Also locate the
three holding screws on the left-side of this
cover. Remove only these three screws with
a small Phillips-head screwdriver. Then
remove the cover by lifting it up.
4. Locate the single memory expansion slot
in the open compartment. Also locate the
off-center key on the slot. There will be a
standard memory module occupying the
expansion slot.
5. In order to upgrade your system past 32MB of memory, its standard
memory module will need to be removed. To remove a memory module,
locate the retaining clips on both sides of the memory module. Gently
pull both clips away from the module and then lift the module out of its
expansion slot.
6. To install a memory module, insert the module into an expansion slot
at an angle and then push it down until it clicks into place. To be certain
that the module is installed correctly, ensure that the off-center notch on
the module is aligned with the off-center key of the expansion slot. The
module can only be installed one way due to the position of the notch.
7. Replace the memory expansion cover back to its original position and
be sure to secure its three holding screws.
8. Insert the battery back into its compartment and turn the system right-
side up.
9. Replace the AC power supply and any other cables you may have dis-
connected.
10. Open the display screen and turn the system on. The computer will
automatically reconfigure itself to recognize the additional memory. The
new memory can be verified during the POST routine at start-up and at
the SETUP utility.
The installation is now complete.
SPEED POWER PERFORMANCE
Viking Memory
INSTALLATION GUIDE
Manual No. 1005246 • Release 07/98, Rev. A
ACER
®
Extensa 365 Series (Model 367T, 367D, 366D)
Copyright 1998 Viking Components, Inc.