Filter
Top Products
VIVOTEK
User's Manual - 181
8.26 Start wireless connection
Note: This request requires Administrator privileges.
Syntax:
http://<servername>/cgi-bin/admin/connect_ap.cgi
This command is only used in pure wireless model (e.g., a model without Ethernet. Ex: IP8336W).
This command triggers camera to start to connect to a Wi-Fi access point. Before use this command,
please setup your wireless settings properly. Note that this command force your camera to switch to
DHCP.
8.27 Site survey
Note: This request requires Administrator privileges.
Syntax:
http://<servername>/cgi-bin/admin/site_survey.cgi
This command is only used in pure wireless model (e.g., a model without Ethernet. Ex: IP8336W)
who is using Realtek RTL8188CUS.
This command returns site survey results with the following fomat:
result = [["1st AP's SSID",1st AP's signal strength,"1st AP's encryption / algorithm"], ["2nd AP's
SSID",2nd AP's signal strength,"2nd AP's encryption / algorithm"], ....., ["last AP's SSID",last AP's
signal strength,"last AP's encryption / algorithm"]];
Ex:
result = [["cerio-gary",68,"WPA2 /
AES"],["TP-LINK_710N",42,"None"],["Guest",26,"None"],["Vatics",10,"None"],["Vivotek",0,"None
"],["CHT Wi-Fi Auto",0,"WPA2 / AES"],["dlink635",7,"WPA2 / AES"],["TL-WR720N",0,"WPA2 /
AES"]];