Filter
Top Products
Using CWIS to Configure Settings on the Machine
Xerox WorkCentre 7232/7242 System Administration Guide 51
DHCP/DDNS:
• Release Registration – Allows DHCP resources to be released when the
machine is powering down. This is a display-only item and shows “Enabled”.
Zero-configuration Networking:
• Self Assigned Address (IPv4) – Allocates an IPv4 address without using a
DHCP server. This check box is selected when [IP Address Resolution] is set to
[Autonet]. This is a display-only item.
• Self Assigned Address (IPv6) – Displays “Enabled”. This is a display-only item.
6. Select [Apply] to reflect the new settings.
7. Enter the user ID and passcode and then select [OK].
NOTE: The default user ID is "11111" and the default passcode is "x-admin".
8. When the reboot message appears, select [Reboot Machine].
SNMP Configuration
This page allows you to configure the SNMP settings.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select the plus symbol [+] to the left of the [Connectivity]
folder.
3. Select the plus symbol [+] to the left of the [Protocols] folder.
4. Select [SNMP Configuration].
5. Set up the following displayed in the frame.
SNMP Properties:
• Enable SNMP v1/v2c Protocols – Allows you to enable or disable the SNMP
v1/v2c protocols.
• Edit SNMP v1/v2c Properties – Displays a page which allows you to set the
following SNMP v1/2c properties.
Community Names:
• Community Name (Read Only): Enter the community name used for display.
• Community Name (Read/Write): Enter the community name used for display
and update.
Default Trap Community Name:
• TRAP Community Name: Enter the trap notification community name.
System Administrator’s Login ID:
• System Administrator’s Login ID: Enter the name of the Key Operator.