Yamaha Rio3224-D Webcam User Manual


 
R Remote Operation Manual 17
Audio is not input / Input level
is low
HA gain is not at an appropriate
level
Set the HA gain to an
appropriate level.
The external device is not
outputting a signal
Output a signal from the source
device and make sure that the
SIG indicators on the
appropriate channels will light.
A condenser microphone is
connected
Turn the [+48V MASTER]
switch on.
Turn phantom power on for the
corresponding channel.
REFRESH mode is selected
with the CL not connected
Select RESUME mode.
Adjusting the HA gain does not
change the audio level
Gain compensation is on
If you don't need gain
compensation, Turn gain
compensation off.
[UNIT ID] rotary switch and
DIP switch settings are not
applied
The settings were changed
while the power was on
Turn off the power before
changing the settings.
The orange [SYNC] indicator
lights (the system enters a state
of synchronization in progress)
In REFRESH mode, R Remote
was connected before the CL
series console
If R Remote is connected first,
this is the normal state; simply
use R Remote to control the
system.
C.S.G., PA Development Division
© 2014 Yamaha Corporation
A1