Yamaha SY-6ICA Computer Hardware User Manual


 
SY-6ICA Quick Start Guide
22
In Device Manager, I keep getting yellow exclamation signs on my sound port
even though I have installed my sound driver several times and I could not get
my sound card to work. What is wrong?
It is likely that you did not have the correct driver installed. If you are sure that the
correct sound driver has been installed, then please install the 'south bridge' driver
for the motherboard.
The sound is working in my system, but when I play CD music from the CD-
ROM, I do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the sound card is not
connected or it is loose.
The sound from my sound card is distorted when Windows starts. What is
wrong?
First, if you are using an ISA sound card, please make sure the IRQ needed for the
sound card is set to 'Legacy ISA' in the bios. In other words, if your ISA sound card
takes IRQ5, then set IRQ5 to 'Legacy ISA'. Next, install the 'south bridge' driver for
the motherboard.
The sound and everything else works fine except that the recorder and
microphone do not work. What is wrong?
This is because the recorder and microphone in the Windows are not enabled.
Please go to sound properties and enable them.
Lock up (freeze)
When I boot up my system, everything works fine. It sees my CPU and
memory, detects my hard drive, floppy drive and CD-ROM but locks up at
"Verify DMI pool data... ", and it won t go any further. What should I do?
Please clear the CMOS via JP5 then choose 'load setup default' in the bios and save
the bios and exit. Next, unplug all other add-on cards except the video card and
floppy drive controller, and see if it can boot from floppy. Then put back the
peripherals one by one to identify which one causes the lockup. If you are running a
Cyrix CPU, make sure the 'linear burst function' is enabled in the bios.
I can not get my board to run properly.
Please make sure you have the latest bios and driver from the SOYO web site at:
http://www.soyo.com