Chapter 5. Configuring the WAN Interfaces
59
Modifying ATM VCs
Your device may contain placeholder values that you must change
to establish an ATM connection. Contact your ISP to determine
your ATM VC values. Follow these instructions to modify a pre-
configured VC:
1. From the ATM VC Configuration page, click
in the
Actions column for the interface you want to modify.
The ATM VC Interface – Modify page displays:
Figure 16. ATM VC Interface – Modify Page
2. Enter the new VPI and VCI values, select the MUX type, or
change the maximum number of protocols that the VC can
carry, as directed by your ISP.
3. Click
.
4. On the confirmation page, click
to return to the
ATM VC Configuration page.
5. If you want the changes to be permanent, follow the
instructions on page
46 to commit them.
If you already have defined a higher-level PPP, EoA, or IPoA
interface that uses this VC, then you can verify that the new settings
work by attempting to access the Internet from a LAN/USB
computer. Contact your ISP for troubleshooting assistance.
