Chapter 5. Configuring the WAN Interfaces
71
13. In the interface table, select all interface names on which
you want to perform bridging and click
.
To enable bridging with your ISP, select the EoA interface and
the LAN interface(s) (eth-0 and/or usb-0).
You can enable bridging on an IP-enabled EoA interface; in this
case, the same interface will be capable of handling both
bridged and routed data packets.
14. Click the Bridging: Enable/Disable link.
The System Mode page displays:
Figure 24. System Mode Page
You can also access the System Mode page from the task bar
in the Home tab.
15. Click the Bridging: Enabled radio button (if not already
selected), and then click
.
A page will briefly display to confirm your changes, and will
return you to the Bridge Configuration page.
16. If you want the changes to be permanent, follow the
instructions on page
46 to commit them.
