Filter
Top Products
1
Installing and Configuring the Gateway
Windows 98/SE/2K/ME/XP and Macintosh OS 10.2
Congratulations on the purchase of your 2Wire gateway. To install your gateway and configure your network,
follow these steps.
Note: Features for different models may vary. Product details will be specified for each particular
model.
Note: TO MAC OS 9.X AND OTHER OPERATING SYSTEM USERS. Users running Mac OS 9.X and
operating systems other than those stated above must perform a manual configuration of the
gateway. Refer to Appendix C for step-by-step instructions.
Insert the 2Wire Setup Wizard CD and follow the on-screen instructions
Do NOT install any equipment until instructed by the CD during your installation.
Enter key code
If you were provided with a 20-digit key code by your service provider, enter it when prompted. If you were
not provided with a key code, refer to Appendix E.
Add computers to your network
Insert the 2Wire Setup Wizard CD into the CD-ROM drive of each computer that you wish to connect to your
network and follow the on-screen instructions.