Filter
Top Products
To remove the faceplate:
1
Loosen the two captive screws securing the faceplate to the chassis.
2
Pull the faceplate away from the system.
Read if replacing
a module
You can replace a module while the system is powered on. Replacing the
module requires that you remove the attached cables from the module’s
ports prior to installing the new module.
To replace a module:
1
Disconnect the cables from the module’s ports.
2
Loosen the two captive screws securing the module to the chassis.
3
Pull the module out of the chassis.
The following figures show termination of unterminated BNC ports using
either a Y connector or a Feed-thru terminator.
Captive screw
Faceplate
Power Run
Processor Power
Fan Temp
Config Inserted
ERROR PCMCIA
LANplex 2500
R
Captive screw
Y terminator
Unterminated
10BASE-2 (BNC)
option module
Green = Active
Yellow = Error
Board
Error
Port Status
Active
Error
12
3
45678
Power Run
Processor Power
Fan Temp
Config Inserted
ERROR PCMCIA
LANplex 2500
R
Unterminated
Board
Error
Port Status
12345
6
7
8
Active
Error
Captive screw
BNC terminating plug