Filter
Top Products
36
Although there are five types of IPX packets, the Filter Control page shows only two
options for IPX filtering. The following table shows how to filter each IPX packet
type:
SNMP
Use the SNMP page to display and enter a community string for the Simple Network
Management Protocol. To communicate with the access point, the SNMP agent must
first be enabled and the Network Management Station must submit a valid community
string for authentication. Select SNMP Enable and enter data into the fields as
described below. When you are finished, click Apply.
n Location—Specifies the access point location.
n Contact—Sets the system location string that describes the system location.
(Maximum length: 255 characters)
n Community Name (Read Only)—Specifies a community string with read-only
access. Authorized management stations are able to retrieve MIB objects.
(Maximum length: 23 characters)
n Community Name (Read/Write)—Specifies a community string with read-write
access. Authorized management stations are able to both retrieve and modify MIB
objects. (Maximum length: 23 characters)
n Trap Destination IP Address—Fill in the IP address box for a trap manager that
will receive these messages.
n Trap Destination Community Name—Fill in the community string box for a trap
manager that will receive these messages. (Maximum length: 23 characters)
ADMINISTRATION
The Administration page allows you to perform access point management tasks as
described below.
n Change Password—A password is required to configure the access point. Enter
the user name and new password in the spaces provided and click Apply. It is
ISO Designator Filter
8138 Enable 8138
8137 Enable 8137
802.3(Raw) Enable 8138
802.2 Enable 8138
SNAP Enable 8137