Filter
Top Products
10
3 Insert the power cable plug directly into the standard AC socket on the power injector.
4 Plug the other end of the power cable into a grounded, 3-pin socket, AC power source.
5 Check the LED on top of the power injector to be sure that power is being supplied to the
wireless bridge through the Ethernet connection.
NOTE: For International use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the socket type in your country.
Input
O
utput
AC power
Power LED indicator
“Input” from
Ethernet Hub/
Switch
“Output” to Bridge