3M 290 Barcode Reader User Manual


 
3M © 2003 78-8078-8977-5 Page 3 of 9 Attest 290 Auto-reader
SAFETY INFORMATION
Power Supply Specifications
Power supply Operating Condition Units
Voltage Range 100-240 Volts AC
Frequency 50/60 Hertz
Current 1.2 Amps
Environmental Operating Conditions
Environmental Condition Operating Condition Units
Altitude 2500 (max) meters
Operating Temperature 16-43 °C
Relative Humidity 20-80 (non-condensing) %
Voltage Range 12 Volts DC
Frequency DC
Current 2.4 Amps
Installation/Over Voltage Category II
Pollution Degree 2
Health and Safety Information
Device Safety Compliance
The Attest 290 Auto-reader complies with the
standard IEC/EN 61010-1 as demonstrated by the
CB Scheme Certificate and test report that
Underwriters Laboratories Inc. (UL) generated.
The Attest 290 Auto-reader is listed as Laboratory
equipment and carries the UL and c-UL marks
based on compliance to the standards UL 3101-1
and CSA 22.2 No. 1010-1.92.
The Attest 290 Auto-reader complies with the CE
mark related to the Low Voltage Directive
73/23/EEC as confirmed in the Declaration of
Conformity.
EMC Compliance
The Attest 290 Auto-reader complies with IEC/EN
61326-1 as confirmed in the Certificate of
Compliance generated by 3M.
The Attest 290 Auto-reader complies with the EMC
requirements of the CE mark EMC Directive
89/336/EEC.
The Attest 290 Auto-reader complies with the
Australian EMC requirements as confirmed in the
Supplier’s Declaration of Conformity that is linked
to the C-tick mark.
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide a reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
is likely to cause harmful interference in which case
the user will be required to correct the interference
at their own expense.
This Class A digital apparatus meets all
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe A respecte
toutes les exigences due Reglement sur le materiel
brouilleur du Canada.