Filter
Top Products
3M
™
Multimedia Projector MP7730
16
© 3M IPC 2000
Standby/On
Standby/On
Standby/On
Standby/ON
Operation
Startup
1. Plug power cord into wall socket.
2. Press the STANDBY/ON button and hold for 3 seconds.
• The ON indicator blinks green and then stays green.
• The ON indicator will blink green during warm-up and lamp ignition.
(When power is turned off, there is a 90-second reset period before the STANDBY/ON button will
function again.)
3. Turn on all connected equipment.
✓
Note: Make all cable
connections and line
hookups with the
power off.
Power
1
2
✓
Note: If you have the Optional Video Module attached to the unit, press the Source button on the remote
to select the source of the signal to be projected onto the screen. The selected signal input is
displayed at the top right of the screen. The display will show the last selected input source before
power was turned off. (For more information, please refer to the Optional Video Module section of
this manual.)
The 2-prong adapter with ground is used with
older U.S. electrical outlets that only support
2-prong power cord plugs.
✓
Note: When using this adapter, the
ground lead MUST be securely
fastened to the ground screw on
the outlet.
Plug the 2-prong adapter into the bottom socket
of the eletrical outlet. Hook the end of the ground
lead firmly around the neck of the outlet’s ground
screw. Tighten the screw, if necessary, to hold the
ground in place. Then plug the power cord into
the adapter.
Ground lead