Filter
Top Products
Installing the Desktop Stand
ET 350 Monitor and ET 3250/55 Computers
Equipment
Materials provided
The Desktop Stand Kit includes:
! 1 pivot plate with rubber foot
! 1 mounting bracket
! 1 angle bracket with rubber foot
! 1 knob
! 7 #10-32 ½-inch screws and lock washers
Tool required
! Phillips No. 2 torque screwdriver
Installing the desktop stand
The desktop stand is a three-piece assembly:
! Pivot plate with rubber foot attaches to the bottom
of the unit.
! Mounting bracket attaches to the back of the unit.
! Angle bracket attaches to the mounting bracket.
Place foam pads or other material on a flat surface to
protect the unit’s bezel and touch screen and set the
ET unit face-down on this surface while installing the
desktop stand.
Attaching the pivot plate
1. Through each of three #10-32 ½-inch screws,
thread a lock washer.
2. Thread the screws with lock washers through the
three holes on the back of the pivot plate.
3. Position the pivot plate so that each screw is
aligned with a hole on the back of the unit
4. Use the screwdriver to tighten the screws to a
torque of 10 inch-pounds.
Intended Use
When properly installed using the materials provided,
and according to these instructions, the desktop stand is
intended to mount the ET 350 monitor and the
ET 3250/55 computers for use on desktop or other flat
surface.
Warning
Read and understand all safety information
before installing and using this product.
To reduce the risk of fire or electric shock
which could result in serious personal injury or
death:
! Follow all product and accessory installation
instructions.
Caution
To reduce the risk of the ET unit tipping over,
which may result in minor or moderate
personal injury:
Do not open the bezel of the unit while it is mounted on
the desktop stand.