Filter
Top Products
13892 (Rev. 1.1) Page 2
Installing the Desktop Stand 3M Dynapro ET 350 Monitor and ET 3250/55 Computers
Attaching the mounting bracket
1. Thread one of each of the remaining four lock
washers through one of each of the remaining
four screws.
2. Thread the screws and lock washers through the
four holes on the back of the mounting bracket.
3. Position the mounting bracket so that each is
aligned with a hole on the back of the unit.
4. Use the screwdriver to tighten the screws to a
torque of 10 inch-pounds
Attaching the angle bracket
Use the knob provided to attach the angle bracket to
the mounting bracket. To adjust the viewing angle of
the display up or down, slide the angle bracket up or
down in the slot before tightening the knob.