Filter
Top Products
3M
™
Multimedia Projector MP8625 © 3M 1998
ENGLISH
8625-16A
2
1
3
4
6.3 Replacing the Lamp
WARNING
Always turn off and unplug projector when changing lamp.
Lamp and adjacent metal parts become extremely hot and can cause severe burns to your fingers. Allow the
projector to cool for at least 30 minutes before replacing the lamp.
1. Remove lamp access door: The lamp access door is located on the back of the machine on the right side.
Use screwdriver to unscrew the cover retaining screw (1) and gently open the cover and set it aside.
2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (2)
✔ Note
There are three lamp module screws that must be loosened. These screws are self-containing screws that
cannot be removed from the lamp module or access door.
3. Remove lamp module: Grasp the lamp module with one hand and the projector body with the other
hand. Carefully slide the lamp module out (3) using steady pressure.
4. Insert lamp module: Carefully insert (4) the new lamp module. Ensure that it is fully seated. Tighten the
lamp module retaining screws (2) to secure the lamp module in place.
Insert the hinge tabs on the left side of the lamp access door, then close and tighten the retaining screw (1)
to secure the door.
✔ Note
Reset the lamp operation hours. See section 6.2 for details.
16
Figure 6.2 Lamp Module