Filter
Top Products
3M™ Multimedia Projector S55/X45/X55 Product Safety Guide
© 3M 200412
√ Note
Reset the lamp operation hours. See “Reset Lamp Hours” for details.
ENGLISH
3. Remove lamp module: Slowly pick up the lamp module by the handles. (4)
4. Insert lamp module: Carefully insert (4) the new lamp module. Ensure that it is fully seated.
Tighten the lamp module retaining screws (3) to secure the lamp module in place.
Optional Lamp: 78-6969-9790-3 (Contact 3M customer Service.)
Insert the hinge tabs on the bottom of the lamp access door, then close and tighten the retaining
screw (1) to secure the door.
(2) Lamp access door
(1) Screw
(2) Screws (4) Handles
√ Note
For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.
Also, do not install an old or previously used lamp.
1. Remove lamp access door: The lamp access door is located on the bottom of the machine. Use a
screwdriver to unscrew the cover retaining screw (1) , then slide and take the lamp access door
up. (2)
2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (3)
√ Note
All lamp module screws must be loosened. These screws are self-containing screws that
cannot be removed from the lamp module or access door.