Filter
Top Products
Office 8K - 8 Buttons Wireless Optical Mouse
- 6 -
UK
The RF-Mouse ID code
Each RF-
Mouse is assigned a unique ID code at manufacture, so the receiver only
picks up the signal from your mouse and prevents other RF-
Mouse radio signals from
operating on your computer. This feature can also be disabled, allowing other
RF-pointing devices to operate your computer.
Connecting the RF-Mouse ID Code
When the driver installation is finished your computer reboots and the RF-Mouse
window (shown on the right) appears. Before setting up the RF-Mouse ID connection,
please make sure there are no other RF pointing devices around and in use.
CONNECT ID: Move the RF-
Mouse for a few seconds to establish a connection, and then click
Connect ID. The unique ID code of your mouse is recognized. Once this process properly
executed, other RF pointing devices will not function on your computer.
Exit: Click Exit to complete the ID setup.
Changing the RF-Mouse ID Code
You can use a new RF-
Mouse on your computer without changing the Radio receiver;
you just need to change the ID code. Refer to the following:
1. Press [Shift + Alt + F11] or [Shift + Alt + F12] to call up the RF-
Mouse ID Code
window.
2. Move the RF-
Mouse for a few seconds to establish a connection, and then click
Connect ID.
3. The new ID code is connected and the RF-Mouse window closes.
Click Exit to close the RF-Mouse ID code window.
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com