Filter
Top Products
REGULATORY STATEMENTS
FCC Part 68 Registration
The high speed PC card FAX/MODEM is registered with the FCC as compliant with
the rules of Part 68, and use of this modem is subject to the following restrictions:
1. The Federal Communication Commission FCC has established rules which permit
this device to be directly connected to the telephone network. Standardized jacks
are used for these connections. This equipment should not be used on party lines
or coin phones.
2. If this device is malfunctioning, it may also be causing harm to he telephone
network; this device should be disconnected until the source of the problem can
be determined and until repair has been made. If this is not done, the telephone
company may temporarily disconnect service.
3. The telephone company may make changes in it’s facilities, equipment, operation
and procedures; if such changes affect the compatibility or use of this device, the
telephone company is required to give adequate notice of the with the FCC.
4. If the telephone company requests information on what equipment is connected to
their lines, inform them of:
a. The telephone number which this unit is connected to
b. The ringer equivalence number.
c. The USOC jack required.
d. The FCC Registration number.
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN)
is used to determine how many devices can be connected to your telephone line. In
most areas, the sum of the REN’s of all the devices on any one line should not exceed
5.0. If too many devices are attached, they may not ring properly.
FCC Part 15 Registration
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult an experienced radio/TV technician for help.
CTR 21 pan-European Certification
This equipment has been approved in accordance with Council Decision 98/482/EC
for pan-European single terminal connection to the public switched telephone
network (PSTN). However, due to differences between the individual PSTNs
provided in different countries, the approval does not, of itself, give an unconditional
assurance of successful operation on every PSTN network termination point. In the
event of problems, you should contact your equipment supplier in the first instance.
This device is designed to work with the notified networks in all EC member states.
Nevertheless, some of the network services in invidual countries might not be
supported, but they will not affect the normal data and fax applications. For example,
the metering charge service in Germany. Besides you may encounter difficulty of
using PULSE dialing function in some of the countries, such as Nordic countries.
This kind of network compatibility is dependent on the physical and software settings
of this device. If the users are desired to use this device on those networks, they
should contact the vendor or supplier first.