Filter
Top Products
- 3 -
INSTALLATION
Hardware Connections
1. Insert the PCMCIA Ethernet card into the
PCMCIA slot with the 68 pin connector toward
your notebook’s PCMCIA slot and the label
facing up.
2. Connect the media coupler to the PC card’s 15-pin
connector.
3. Connect one end of an Ethernet cable to the
coupler media. Plug the other end of the cable into
a switch hub.
Software Installation
Insert the driver diskette into the floppy drive and set
the current drive to the floppy drive. Then run
INSTALL to install the real mode drivers such as ODI
or NDIS 2.x or Packet Drivers into the target disk.
Windows 95 Installation
Make sure that the drivers of PCMCIA slot are well
installed. The System Icon in the Control Panel can
report on its functionality. Apart from above mentioned,
any questions on this layer need to be taken up with the
computer's manufacturer.
1. Insert PCMCIA Ethernet Card into PCMCIA slot.
In New Hardware Found dialog box, select Driver
from disk provided by hardware manufacturer”.