Filter
Top Products
-6-
IOP-048 24-Point Photocoupler Input Board / 24-Point Transistor Output Board
[Characteristics]
This is a dedicated input/output board equipped with 24-points for each input and output.
Each input/output is equipped with an LED monitor. The input and output interfaces have
equivalent specifications with MOP and MIP, respectively.
[Specification]
Power source: DC (5V) 12V~24V (for I/O control).
24-point optocoupler input. 24-point open collector output.
* If used with DC 5V, the resistor array needs to be replaced.
Consumed current: 50 mA
[Accessories] (1) Power connector (H4P-SHF-AA) JST *1
(2) Contacts (BHF-001T-0.8SS) JST *4
MPG-3202 S-Shape-Compatible PG Board & Encoder Counter Board (2-Axis)
[Characteristics]
A general-use PG board loaded with pulse generation and counter ICs that can support
two axes. Interface of the pulse output and the encoder is RS-422 specification that can
deal with high-speed (1M pps) pulse output and input. The mounted PGIC is X3202 that
can deal with the S shape and is equipped with various intelligent functions.
[Specification]
Power source: DC 12V~24V
Pulse output: Differential pulse output *2 axes / RS-422 specification * 2 axes
Encoder input: Differential pulse input (A-B phase encoding) * 2 axes
[Accessories] (1) Power connector (H4P-SHF-AA) JST *1
(2) Contacts (BHF-001T-0.8SS) JST *4
MRS-402 RS-232 Expansion Board RS-232C
[Characteristics]
This is a 2CH RS-232C(RS-485) expansion board, of which up to two can be installed. Because
it is an intelligent design by dual-port RAM, it does not provide burden on the CPU. The
interface is photo-isolated, and the modem control terminal is RTS×CTS only. Software support
is dealt with in a similar way to the standard commands and functions, assigned to #3~#6.
[Specification]
RS-232 standard interface. Input buffer 1K byte.
Consumed current: 50 mA
[Accessories] (1) Power connector (H4P-SHF-AA) JST *1
(2) Contacts (BHF-001T-0.8SS) JST *4
MPS-324 3A Power Source Board 4(8)-Point Relay Output
[Characteristics]
Although MPC-68K is equipped with a 1 A power source, when the system scale becomes
large, it becomes short of current. In a large-scale system, this MPS-324 is used. The
supplied current is 3 A. Also, MPS-324 is equipped with a 4-point relay output circuit (4
more relays can be further added). A PC98-bus compatible DC ±12 V DC-DC converter
can be installed on the board. By this, peripheral boards for 98 requiring ±12 V power
source can be used.
[Specification]
Power source: DC 24V±10%. 4(8)-point relay output.
Consumed current: 3 A supply
[Accessories](1) Power connector (H4P-SHF-AA) JST *1
(2) Contacts (BHF-001T-0.8SS) JST *4
(3) Connector (HIF-3BA-34D-2.54R) Hirose *1
(1)
(2)
MRS-402 CEP-059
ACCEL CORP
.
(1)
(2)
(1)
(2)
(3)
MPG-3202 CEP-075
ACCEL CORP.
(1)
(2)