Filter
Top Products
ILLUSTRATED PARTS MANUALS
T300 THERMAL BINDER
220-240V
T300.doc 15
SERVICE INSTRUCTIONS
This manual provides instructions for the replacement of components that may become worn or damaged.
WARNING
Check rating plate details are compatible with electric supply. Disconnect mains supply before removing
cover.
SECTION 6.0 (From serial no A545818)
Replacement of Top Cover
17. Ensure that mains cable is disconnected from the supply.
18. Remove the two rubber feet that are on the left hand and right hand side, towards the front of the
machine.
19. Remove the six fixing screws using a pozi drive screwdriver.
20. Lift base of machine away from top cover and place on a nearby flat surface.
21. The top cover should now remain face down.
22. Remove the four screws securing the PCB.
23. Remove the PCB, by unclipping the three crimp housings on the thermistor, mains connection and
the heater.
24. Remove the four buttons.
25. Ensure document support bar is in down position on top cover.
26. Remove the spring that fixes the document support bar to the lever arm, by unhooking it from the
screw boss, on the rear right hand side of the machine and place on one side.
27. Unhook the lever arm by pulling the lever upwards, towards, the inside of the cover; slide it over the
end of the bar and place on one side.
28. Turn the top cover over, so that the document support bar is facing you.
29. Lift the document support bar upwards and squeeze the extended legs on the bar together.
30. Release bar and remove from top cover.
31. Replace top cover.
32. To reassemble machine reverse order of operations 1 – 12.
Issue No 1