Filter
Top Products
ARAID 1500, ARAID 2000 User’s Manual
11
Accordance Systems Inc.
Auto Rebuild Instruction (ARF) for RAID 1
1. Have one hard drive in the Upper Bay of your ARAID disk array and set the front panel
operational mode switch set to Single mode and boot your PC.
2. Once the computer is up, change the operation mode switch from Single to Default and
install a target disk into the Lower Bay. (NOTE: If you install target disk without changing
disk operation mode to Default, the system will report target disk as OFF in the LCD
window.)
3. ARF (Auto Rebuild Function) will start automatically and copy the contents of the source
disk onto the target disk.
4. While the disk is rebuilding, the completion percentage is displayed on the front panel
LCD.
5. Typical rebuild rate is 30 ~ 80 GB/hour with maximum transfers of up to 120 GB/Hr.
6. The LCD will signify rebuild completion and show status of both disks.
ARAID 1500 LCD screen after auto rebuild is completed.
ARAID 2000 LCD screen after auto rebuild is completed.