Filter
Top Products
3
Hardware Installation
1. Select an empty CardBus PC Card slot and insert the
Fast EtherCard-32 into that slot as shown below.
2. Connect the RJ-45 media coupler’s 15-pin connector
to the PC card.
3. Connect the media coupler to a network hub or switch
using UTP cable with RJ-45 connectors. Use
Category 3, 4 or 5 for 10Mbps connections and
Category 5 for 100Mbps connections. The UTP cable
should have a maximum length of 100m (328ft).
Fast EtherCard-32
LED Indicators
RJ-45 Connector
Host PC
Hub
4. Power on your PC and install the appropriate network
driver for your operating system. Drivers can be
found on the Driver Diskette.