Accton Technology ES4524M-POE Switch User Manual


 
1-1
Chapter 1: About the
ES4524M-PoE
Overview
The ES4524M-PoE is an intelligent Layer 2 PoE switch with 24 10/100/1000BASE-T
ports, two of which are combination ports
*
that are shared with two SFP transceiver
slots (see Figure 1-1, Ports 23-24).
The switch includes an SNMP-based management agent embedded on the main
board, which supports both in-band and out-of-band management access.
It can easily enhance your network with full support for Spanning Tree Protocol,
multicast switching, and virtual LANs. It brings order to poorly performing networks
by segregating them into separate broadcast domains with IEEE 802.1Q compliant
VLANs, and empowers multimedia applications with multicast switching and CoS
services.
Figure 1-1 Front Panel
Figure 1-2 Rear Panel
Switch Architecture
This Gigabit Ethernet switch employs a wire-speed, non-blocking switching fabric.
This permits simultaneous wire-speed transport of multiple packets at low latency on
all ports. The switch also features full-duplex capability on all ports, which effectively
doubles the bandwidth of each connection.
For communications within the same VLAN, the switch uses store-and-forward
switching to ensure maximum data integrity. The entire packet must be received into
* If an SFP transceiver is plugged in, the corresponding RJ-45 port is disabled for ports 23-24.
10/100/1000 Mbps RJ-45 Ports
Console Port
Port Status LEDs
SFP Slots
Power Socket
100-240V~
3A 50-60Hz