Filter
Top Products
Chapter 5 91
Jumper Settings/Clear BIOS Password Procedures
1. Remove the DIMM cover and the lower DDR2 memory module, then find out the G70 position on the main
board. Please just the lower DDR2 memory module, you will need the upper DDR2 memory module to
boot up the system.
2. Use a tweezers or a screwdriver to short the G70 pad and remain the short status.
3. Power on the system until POST is completed. Then you can release the tweezers or screwdriver. The
BIOS password should be cleared after these steps.