Acer S5301WB Projector User Manual


 
39
English
Replacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the
lamp.
The projector will detect the lamp life itself. It will show you a warning message
"Lamp is approaching the end of its useful life in full power operation.
Replacement Suggested!" When you see this message, change the lamp as soon
as possible. Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
Warning: Lamp compartment is hot! Allow it to cool down before
changing lamp!
To remove the lamp:
1 Turn the projector off by pressing (POWER).
2 Allow the projector at least 30 mins to cool down.
3 Disconnect the power cord.
4 Use a screwdriver to remove the screws from the cover. (Illustration #1)
5 Push up and remove the cover.
6 Remove and dispose of the lamp protection film (Illustration #2).
7 Remove the screw that secures the lamp module (Illustration #3).
8 Pull out the lamp connector from a slot in the lamp compartment.
Disconnect it from the projector (Illustration #4).
9 Lift the handle so that it stands up (Illustration #5). Pull out the lamp
module by force (Illustration #6).
To replace the lamp module, use a new lamp and follow illustrations # - # .
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
1
12
1
12
6
5
7
8
8
10
9
4
3
1
2
1
2
11
2
7
112