Filter
Top Products
51
Installing an expansion card
Note: Observe the “Installation precautions” on page 43 when
installing or removing a computer component.
To install an expansion card:
1. Remove the side panel (see page 45).
2. Locate an empty PCI slot on the mainboard.
3. Remove the screw that holds the bracket to the computer. Save
the screw.
4. Pull out the bracket on the housing opposite the selected empty
slot.
5. Remove the expansion card from its protective packaging.
6. Align the card with the empty bracket and then insert it into the
slot. Make sure that the card is properly seated.
VT7200-ug-e.book Page 51 Wednesday, July 18, 2001 1:28 PM