Appendix
57
PC 8150 User
’
s Manua
l
SHORT
C
I
RCUIT
PROTEC
TI
ON
Output short circuit is defined to be a short circuit load of less than 0.1
ohm.
In the event of an output short circuit condition on +3.3V, +5V or +12V
output, the power supply will shutdown and latch off. The power
supply shall return to normal operation after the short circuit has been
removed and the power switch has been turned off for no more than 2
seconds.
In the event of an output short circuit condition –12V output, the power
supply will not be latch off.
The power supply shall return to normal operation as soon as the
short circuit has been removed and the power switch has been turned
off for no more than 2 seconds.
OVERLOAD
PROTECTION
Overload currents defined as a 10 amp/sec fault current ramp starting
from full load, applied to the +3.3V, +5V output, shall not cause that
output to exceed 32 amps before the output voltage drops below 0.5
volts and is latched off. The +12V output shall not exceed 20 amps
under the same ramp conditions starting at full load before it is latched
off.
POWER
GOOD
SIGNAL
The power good signal is a TTL compatible signal for the purpose of
initiating an orderly star-up procedure under normal input operating
conditions. This signal is asserted (low) until +5Vdc has reached
4.75 volts during power up. Characteristics:
TTL signal asserted (low state) : less than 0.5V while sinking 10mA.