Filter
Top Products
GRN4-610 Chapter 3: Installation 37 of 73
Start-up Checklist
! When the housing panel is opened, check the cutter mounting screws using a
torque wrench.
! Search the grinding chamber for foreign matter.
! Check oil level of the gearbox motor.
! Examine in-feed device for foreign matter.
! Check that they Emergency Stop buttons are unlocked.
! Check all safety devices for proper function.
! Switch ON the machine for a short time to check the rotational direction—can be
seen at the discharge air fan of the drive motor—observe the running direction
arrow.
! Allow machine to run approximately 10 minutes without grinding material.
! Connect material discharge and in-feed device; check rotational direction drives.
! Feed grinding material uniformly; too much material can cause the machine to
overload.
! Check the temperature of ground material if necessary.
! Monitor the ammeter. This displays the present current consumption and
provides information on the load of the machine.