Filter
Top Products
24 PCM-3420 User's Manual
the host adapter and other hardware in your computer. You can fix
this zby changing the hardware resource settings.
Q:What do I need to do if I change or upgrade my host adapter ?
A:
1. Open the Control Panel, double-click on system, and click the
Device Manager tab.
2. Double-click the SCSI Controllers icon, select the name of the old
host adapter, and click remove.
3. Turn off the computer and physically remove the currently
installed host adapter.
4. Turn the computer On. If the host adapter supports Plug and
Play, Windows will install and configure it automatically. Other-
wise, run Add New Hardware to make sure the new driver is
loaded.
Q:If I am running under Windows 95, do I need lines for the Adaptec
real mode ASPI drivers and mscdex in my config.sys and
autoexec.bat files?
A:Usually, you do not need to use these real mode ASPI drivers,
because the new Windows miniport drivers support most SCSI host
adapters and SCSI Devices. However, you need to load the drivers
(including mscdex, if you have a CD-ROM drive) if any of the
following is true :
l You are running in MS-DOS mode.
l You are using a scanner or another SCSI device with config.sys-
based or autoexec.bat-based drivers, such as HP's sjiix.sys.
l You have an older model SCSI CD-ROM drive that Windows 95
does not support.
l You are using a CD-Recorder drive (however, some newer models
of CD-Recorder drivers can use the embedded Windows miniport
drivers)
To install the Adaptec EZ-SCSI DOS drivers, click the Start Button
and select Restart the computer in MS-DOS mode. When the DOS
prompt appears, follow the Quick Start instructions for DOS on
previous section.
Q:My CD-ROM driver doesn’t work properly under Windows 95 ?
A:Some older models of SCSI CD-ROM drivers are not compatible with