Filter
Top Products
6
3 Remove the tower’s front bezel, as shown below, saving the
screws for use in Step 5.
4 Turn the enclosure 90° so that the right hand rack mount ear
and LEDs are on top, then slide the Storage Enclosure into the
tower skin, as shown above.
5 Replace the front bezel, using the screws removed in Step 3.
6 Install the tower labels at the top and bottom of the tower. Align
the holes in the top label with the LEDs on the enclosure.
7 Replace the drive carriers and APCs, if necessary.
The tower assembly installation is complete. Continue with Step 2:
Installing the Drive Carriers, below.
Step 2: Installing the Drive Carriers
These instructions assume that the drive carriers have already been
attached to your disk drives.
Caution: Acclimate new disk drives to room temperature
before you install them and power up the Storage Enclosure.
To install the drive carriers into the Storage Enclosure:
1 Hold the drive carrier with the LEDs on the left side (at the
bottom for tower-mounted systems) and select an open disk
drive slot.
Note: It is easiest to install the drive carriers from left to
right on the Storage Enclosure.
Step 3 Step 4
!