Filter
Top Products
AdderView MATRIX MP Installation and Use Page 58
USERS ADMIN Alan Jim Sue Test
PASSWORDS password letmein hello logmein Test
COMPUTERS PORT
Admin PC 2103 1 1 1 1
Alan's System 2102 1 1 1
Comms Server 3 1 1
Comms PC 4 1 1 1 1
Gateway 1 8 1
Gateway 2 5 1
Test System 15 1 1
Web Browser 9 1 1 1
To restore the saved / edited menu and configuration settings:
1. Connect the serial port on the rear of the AdderView MATRIX MP to a serial
COM port on your computer using the serial cable supplied with the AdderView.
2. Copy the program AVMWRITE and AVMDATA.CSV into the same directory on
the PC that is connected to the AdderView’s serial port.
3. Run the program AVMWRITE.EXE and follow the instructions given by the
program.
4. Make sure that you are logged onto the AdderView as the ADMIN user. From the
main selection screen press F1 for More Menus. In the Configuration Menu
select Functions. In the Functions menu select Read Data from RS232 port.
5. The AdderView should then receive the configuration data to your computer and
load the new menu names and access rights into the menu.
4.20 Switching channels by sending RS232 data
You can switch the AdderView MATRIX MP remotely by sending RS232 data to the
serial communications port (located on the rear panel adjacent to the power
connectors). All data should be sent using the following RS232 protocol.
Baud: 19200, bits: 8, stopbits: 1, parity:none