Filter
Top Products
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Overview
Hardware Installation
1. Make sure the computer is OFF.
2. Insert the controller into a PCIe 8X or 16X slot.
3. Insert the SAS cable(s) with the retainer side away from the board.
4. If desired, connect the ACT LEDs, anode to a 3.3V pin, cathode to the signal pin. For standard
LEDs, use a 120-150 Ohm load resistor in series.